With these features off you are allowing the firmware to handle their support. Speeds, including SuperSpeed (5 Gbit/s) and future speeds, under a The xHCI architecture was designed to support all USB Mbit/s and 12 Mbit/s), and the EHCI only supports USB 2 devices (480 The OHCI and UHCI controllers support only USB 1 speed devices (1.5 This means you effectively have no input devices that can be detected by WinPE. The reason the keyboard and mouse do not work is due to the fact, XHCI handles USB 3.0 support, and EHCI handles USB 2.0 support. You should also enable Port 60/40 Emulation since that deals with the emulation of a PS/2 keyboard and mouse. You need to enable both XHCI Hand-off and EHCI Hand-off in order to solve your problem. Given you have both XHCI Hand-off and EHCI Hand-off disabled, the Windows installation environment, is unaware of your USB devices. So the mouse will just not move and attempting to navigate using the keyboard does not work. I purchased a Windows 10 USB (rookie mistake, I know) and when I begin the installation process, literally after BIOS, the screen appears to freeze. USB Mass Storage Driver Support - Enabled I have tried changing the USB slots of my mouse and keyboard.Īny suggestions will be greatly appreciated! I have turned off integrated graphics but also tried with them on and plugged into the mobo, the same issue occurs. I have my HDMI connected to the GPU, the GPU is all lit up and the fans are working. I can navigate through BIOS just fine but I cannot get past Windows Setup as shown here: I have definitely learnt a lot and I am now up to installing an OS.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |